Chip Collection
This tool is provided with a chip collector compartment. When the chips
accumulate up to the see-through window, remove the cover, clean out
the cover, then replace it, and tighten the knobs.
Notice
: The metal chips
inside the cover may be very hot and sharp - do not touch with bare
hands.
Dust Extraction
To allow the fitting of a dust extractor pipe, remove the small black cover
located at the top left of the chip collection cover. Replace the cover
when a dust extractor is not in use.
Maintenance And Troubleshooting
Keep tool, cord, and carry case clean and
free from chips
. Avoid using
cleaning products, which include benzene, trichloroethelene, chloride,
and ammonia as these can damage plastic parts. In case of electrical or
mechanical malfunction, immediately switch off the tool and disconnect
the plug. Excessive sparking may indicate the presence of dirt in the
motor or worn out carbon brushes. Check for wear and replace when
they reach 1/4” (6mm). For all other service please contact our Technical
Helpline.
Lubrication
Your machine is lubricated at the factory with sufficient lubricant to last for
approximately 72 hours of operation. To add lubricant, it is necessary to
dismantle the tool. Please contact our Technical Helpline for information
regarding this operation.
Accessories – Genuine Evolution Brand Blades
20T 7-1/4” (185mm) TCT Multi Blade
Notice: Normal wear and tear and damage caused by misuse
is NOT covered under the 12-Month guarantee.
Gebruiksaanwijzing
Belangrijk
De gebruiksaanwijzing en veiligheidsvoorschriften aandachtig
doorlezen. Het voltage verifiëren en controleren of alle handgrepen
en onderdelen stevig vastzitten met het oog op uw veiligheid. Neem
contact op met uw distributeur in geval van twijfel.
De gebruiksaanwijzing op een veilige plaats bewaren
Technische gegevens model Rage 1
Motor (230V 50/60 Hz) (Watt):
1050
Max. zaagcapaciteit (3mm zaagsnede 90
0
) (mm):
55
Max. zaagcapaciteit (3mm versteksnede 45
0
) (mm):
35
Maximale zaagdiepte (vloeistaal) (mm):
6
Maximale zaagdiepte (hout) (mm):
25.4
Onbelast toerental (min-1):
3500
Aanbevolen maximale inschakelduur (minuten):
30
Geluidsdrukniveau (belast) (dB(A)):
100.8
Trilniveau (belast) (m/s
2
):
4.8
Gewicht (Kg):
5.5
Maximale afmetingen (mm):
H 280 B 395 D 450
Minimale afmetingen (mm):
H 240 B 260 D 400
Zaagblad afmetingen
Maximumdiameter (mm):
185
Boordiameter (mm):
20
Dikte (mm):
2
Meegeleverde standaarduitrusting: 1 zijhandgreep, 1 langsgeleider, 1
3
22
