www.evolutionbuild.com
10
OPERATION
GETTING STARTED
WARNING: ALWAYS DISCONNECT THE
SAW FROM THE POWER SOURCE BEFORE
MAKING ADJUSTMENTS.
Refer to the “Service Parts Diagram”. Install
a blade as detailed in the “Installing or
Removing a Blade” section.
WARNING:
Never start the saw with the
cutting edge of the saw blade in contact with
the workpiece surface. Do not retract blade
guard manually. Guard retracts automatically.
This saw is equipped with an approved cord
and plug for its intended Country of use. Do
not alter or modify the power cord.
Installing or Removing a Blade
WARNING:
Only use genuine Evolution
blades which are designed for this machine.
Ensure that the maximum speed of the blade
is compatible with the machine. Only perform
this operation with the machine disconnected
from the power supply.
Note:
It is recommended that the operator
considers wearing protective gloves when
handling the blade during installation or when
changing the machines blade.
1. Place saw on a level, secure surface.
2. Lock the machine arbor by engaging the
arbor lock.
(Fig. 1)
3. Using the supplied Allen Key loosen and
remove the arbor socket headed screw
and outer blade drive flange.
(Fig. 2)
4. Remove the saw blade.
5. Thoroughly clean inner and outer blade
drive flanges and blade mounting surface
before installing a new blade.
6. Ensure that the direction of rotation
arrows printed on the blade, match the
direction of rotation arrow found on the
machines upper and lower guard.
(Fig. 3)
FIG 1
FIG 2
FIG 3
TIGHTEN
