17
www.evolutionpowertools.com
Fig. 15
Dispose of any collected debris in an environmentally
responsible way.
THE GLASS SIGHT SHIELD
A toughened glass shield is located to the front left hand side of
the upper blade guard near where the blade will emerge from a
cut.
(Fig.15)
This allows the operator to monitor the progress of
a cut, whilst providing protection from any ejected material.
Note: This glass shield should be cleaned as required to ensure
a clear and unobstructed view of the cut line.
Note:
All CCS series machines are equipped with a cutting line
debris blower. This directs air from a motor driven fan towards
the area to the front of the blade, thus keeping the cutting line
relatively debris free.
This feature will aid the operator sight and follow the progress
of the saw blade along the cut, keeping any marking-out
lines visible.
WARNING:
Any and all dust created is potentially prejudicial
to health. Some materials can be particularly harmful, and the
operator should always wear a dust mask which is suitable for
the material being worked with.
Professional help and advice should be sought if the operator
is at all unsure about the potential toxicity of the material to
be cut.
WARNING:
These machines must never be used to cut
Asbestos or any material that contains, or is suspected to
contain, Asbestos.
Consult/inform the relevant authorities, and seek additional
guidance if Asbestos contamination is suspected.
(16)
ON/OFF TRIGGER SWITCH
To start the motor:
• Press the trigger switch.
To stop the motor:
• Release the trigger switch.
WARNING: The motor should never be started with the saw
blade in direct contact with any surface of the workpiece.
