Evolve HT-200, User Manual

*GOR_3GOTZKTGTIK

1.Adjustment of running belt

1.1 Adjustment of running belt is equipped with two functions: adjustment of degree of tightness and central 
position of running belt. The running belt has been adjusted when leaving the factory, but it will be

FRPH

 stretched 

after use to deviate from central position to cause damage by wearing trim strip and rear protecting cover. It is 
normal to stretch the running belt in use.

If the running belt is slip or not smooth when you use the treadmill, you 

can improve it by adjusting degree of tightness of running belt.
1.2 How to adjust running belt
1) Insert 5mm hexagon wrench into the regulating screw on the left of running belt, and turn the wrench by 1/4 of a
circle clockwise to regulate the rear roller to tighten the running belt.
2) Repeat step 1 to adjust the screw on the right. Ensure that the regulating screw is turned by the same distance to
make the rear roller parallel with the frame.
3) Repeat step 1 and 2 until the running belt does not slip.
4) Note: the running belt shall not be too tight, which will damage the running belt, roller bearing, etc., increase
pressure of front/rear roller, and bring abnormal sound or other problems. To reduce tension of running belt, please
turn the wrench anticlockwise by same distance on both sides.

Notes

：

Please don’t clean the treadmill with sandpaper or solvent. The controller of treadmill shall not be 
directly exposed to sunlight or damp

QHVV

 to prevent damage.

Don’t expose electronic elements to sunlight or damp

QHVV

.

Frequently inspect and lock all parts of treadmill and immediately replace the damaged parts.

11 

www.evolve-fitness.eu