LCD Screen People Counter - Installation and Operation Guide
© 2016 EvolvePlus Pty Ltd
4
www.evolveplus.com.au
Battery Installation
The people counters are delivered closed and not secured with screws. Open the covers and place batteries
into battery compartment carefully taking note of the correct polarity.
When the transmitter counter (PTx20-1 or PTx10-1) is powered correctly the red LED in the circuit board will
flash.
When the receiver counter (PRx20D1 or PRx10D1) is powered correctly the LCD display screen will show ‘0’.
Install People Counters
When mounting the People Counters take care of the following:
§
The maximum distance between the transmitter PTx20-1 and receiver PRx20D1 is 8 metres.
§
The maximum distance between the transmitter PTx10-1 and receiver PRx10D1 is 10 metres.
§
Use a wall or another steady object to mount People Counters (Metal brackets are available for
purchase if required).
The units are supplied with a Mounting Plate.
Detach the mounting plate from the rear of the units by
sliding the plate up.
The mounting plate can be attached to the fixed object using the supplied screws.
The units are then attached to the mount plates by sliding back of the units over the
mount plates.
Note: in some cases organisations have used double sided Velcro tape to affix units
to
the fixed objects, which allows them to test the counting distance before attaching
the
units to the walls with screws.
An optional right metal bracket is available to suit the RF, USB and Display Only People Counters:
ENI (Enhanced Noise Immunity)
The PRx20D1 and PRx10D1 are equipped with ENI technology which enables them to work in environments
where transmission noise exists. If there is too much transmission noise the red LED on the receiver will light
up. In this case, find the source of the disturbance and remove it.
Additional information
The measurement width of 8 and 10 metres will decrease when the infrared signal goes through
glass.
