INSTALLATION AND CONFIGURATION MANUAL
DIO88
4
2 Unpacking and Placement
Unpacking
The EVS Synapse card must be unpacked in an anti-static environment.
Care must be taken NOT to touch components on the card – always
handle the card carefully by the edges. The card must be stored and
shipped in anti-static packaging. Ensuring that these precautions are
followed will prevent premature failure from components mounted on
the board.
Locating the card
The Synapse card can be placed vertically in an SFR18 frame or
horizontally in an SFR08 or SFR04 frame. Locate the two guide slots to
be used, slide in the mounted circuit board, and push it firmly to locate
the connectors.
Correct insertion of card is essential as a card that is not located properly
may show valid indicators, but does not function correctly.
Note
: On power up all LEDs will light for a few seconds, this is the time
it takes to initialise the card.