21
KPM.X.Systemhandbuch_X3.0.EN.V1.9 | 05/2019 | Subjects to misprints and technical changes.
Battery replacement procedure
1.
The battery compartment is located in the outside handle of the Xesar handle. You require
one type CR123A battery (please ask you retailer for a list of recommended battery models)
and the following tools to open the battery compartment: Allen key, 2.5.
2.
If you would like to remove the handle tube of the outside handle, use the Allen key and
turn the attachment screw clockwise until you can remove the handle tube.
3.
Make sure you only screw in the attachment screw as far as absolutely necessary.
4.
Now remove the empty battery and replace it with a new battery you acquired earlier. En-
sure correct polarity when inserting the battery.
5.
Once again position the handle tube on the outside handle and fasten it in reverse sequence.
The component outputs a signal to confirm having correctly completed the battery
replacement (signal 8 in the signal table from section:
Xesar access components signal events
).
Battery replacements or power cuts must not exceed a duration of one minute
as otherwise the Xesar handle must be resynchronised using the Xesar tablet.
2.1.3
Xesar cylinder
Figure 7: Xesar cylinder (sample image)
Xesar cylinders are battery-operated access components.
The standard Xesar cylinder variant already comes with a host of anti-manipulation protection
measures. Please refer to the product catalogue for more information.
Xesar cylinders are suitable for indoors and outdoors as well as fire and emergency exit doors.
Xesar cylinders are available as half cylinders or double cylinders with one-sided or double-sided,
electronic access.
Please carefully check the Xesar cylinder you selected is suitable for your application.
Please refer to the corresponding data sheet for additional specifications at:
https://www.evva.com/at-de/xesar/
https://www.evva.com/uk-en/products/electroniclockingsys-
temsaccesscontrolsystems/xesar/
