Xesar 3.0 | V 3.0.216
9 / 11
After having completed the parameter configuration, click
Save
to complete the
Xesar network adapter configuration.
To transfer the data to the Xesar Ethernet Adapter, press "Reboot".
Figure 9
: Xesar network adapter - parameter settings
After rebooting the network adapter, disconnect the Xesar network adapter from
the configuration PC. Then connect the Xesar network adapter to the Xeasar LAN
network.
Typically 150
different IP addresses can be defined for the Xesar network which
means that you must define as many as
150
different IP addresses.
Also check the network settings of the PC and observe the valid IP address range of
your network.
•
The Subnet mask defines the subnet used.
•
The Remote Address /URL corresponds to the IP address of the computer on which
the Xesar software is operated. It is responsible for the communication between
the Xesar network adapter and the Xesar software.
It is important that the remote port (9081 by default) is the same as that specified
in the Xesar Installation Manager (OCH Port).
