5
Assembling the Appliance
• Insert the handle into the aperture at the top
of the body aligning the notch on the tube with
the rear of the unit, and straighten the security
collar (Fig.1).
Changing the pads and plates on your
product
• Make sure machine is not plugged in before
fitting pads.
• Note the orientation of the drive hubs (Fig.2).
• Place the required velcro-plate or brush plate
over the hub and rotate until the shape lines
up (Fig.3).
• Press the plate down to clip into place (Fig.4).
• Always use two plates of the same type, i.e.
not 1 brush and 1 pad (Fig.5).
• Simply pull the plates off to remove and
change.
Adjust the handle to suit your height (Fig.6).
Fig.2
Fig.3
Fig.4
Fig.5
Fig.1
Fig.6
Summary of Contents for FP160
Page 9: ...9 Notes ...
Page 10: ...10 Notes ...
