Ewellix CLSM-150-B A Series, Installation, Operation And Maintenance Manual

23

8.0 M a inten a n c e

8.0  Maintenance 

Personnel

•  Daily maintenance work described herein can be per-

formed by the Operator.

•  Some maintenance tasks should only be performed by 

specially trained, qualified personnel employed by the 

product owner, or exclusively by personnel of the manu-

facturer; specific reference as to who should perform the 

maintenance will be made in each case in the description 

of the respective maintenance task.

•  Only professional electricians should perform work on 

electrical equipment.

8.1  Maintenance plan

Maintenance tasks that are required for optimal and trou-

ble-free operation are described in this section.
If increased wear is detected during regular inspections, 

shorten the required maintenance intervals according to the 

actual indication of wear.  

Interval

Maintenance work

To be carried out by

Daily

Check the linear module for 

visible damage (see 8.2.2 

Check of visual condition).

Operator

Clean off dust and dirt if 

necessary (see 8.2.1 Cleaning). Operator

Monthly

Check tight fit of the parts and 

options, correct if necessary

Check connection for tight fit

Qualified personnel

Annually

Check labels and warning 

notices for legibility and 

Replace if necessary

Qualified personnel

Semi-

annualy

Check options for visible 

damage

Qualified personnel

CLSM linear module maintenance plan

NOTICE

If the linear module is used outside of the environment 

conditions specified earlier in this manual, check such 

components once a month for any changes such as oxidation or 

sedimentation.

8.2  Maintenance work 

8.2.1  Cleaning

Cleaning is to be performed by operator.
•  Clean the surface of the linear module and the place in 

which the module is used.

•  Inspect and wipe out leaked grease.
•  Make sure there is no liquid around the device.
•  Check and remove any dust or foreign materials from the
•  Module. 

NOTICE

Damage due to incorrect cleaning

•  Do not use any aggressive cleaning agents. Water used for 

cleaning, including chemical additives, must be pH-neu-

tral.

•  Liquids must not touch the module during operation.
•  Only use the auxiliary materials.
•  No steam jets or pressure washers may be used for clean-

ing.

•  Other cleaning agents or cleaning devices may only be uti-

lized with the Ewellix’s approval.

Note

Clean dirty parts with a damp cloth that does not cause rust.