User Manual
EW-M47
14
See also:
2.2 Battery charging on page 15
2.1.10 The XLR charger connector
Figure 27: The XLR charger
connector
The XLR charger connector, which is located on the right-hand side of the
Remote, is used to connect to either a ba�ery charger or the LiNX Access
Key.
Warning:
Make sure that the battery charger that is used with the vehicle has a drive inhibit function that is correctly
connected for use with the controller. The maximum voltage on the inhibit pin must not exceed 3V if a battery
voltage is to be detected when the battery charger is connected. If you are not sure, ask your dealer or vehicle
manufacturer.
The XLR charger connector on the Remote is to be used exclusively for the intended purpose. Warranty will be
voided if any unauthorised device is connected to this port.
2.1.11 The LiNX Communica�ons Bus connector
Figure 28: The LiNX
Communica�ons Bus
connector
The LiNX Communica�ons Bus connector can be found on the lower front of
the Remote (see Figure 28: The Remote: user interface and connectors). The
LiNX Communica�ons Bus loom plugs directly into this socket, providing the
Remote with both power and communica�on to the power module.