Design and function
MIG/MAG welding
099-005507-EW501
13.09.2018
63
5.4.15 Expert menu (MIG/MAG)
The Expert menu has adjustable parameters stored that
don’t require regular setting. The number of
parameters shown may be limited, e.g. if a function is deactivated.
5.4.15.1 Selection
A
B
A
B
A
A
A
A
A
A
A
B
B
B
B
B
B
B
Figure 5-55
Display
Setting/selection
Burn-back time
> see 5.4.15.2 chapter
• ----------- Increase value > increase wire burn-back
• ----------- Decrease value > decrease wire burn-back
Setting JOB-dependent program limit/n-cycle
> see 5.4.15.3 chapter
1 ---------- No JOB-dependent program limit
2
–9 ------- JOB-dependent program limit for max. selectable programs.
For machine versions with pulsed arc welding procedures only.
Change welding process (process switching)
With this function activated the welding process switches from standard arc welding to
pulse arc welding. Switching is effected by either tapping the torch trigger (special
latched) or by activating the superPuls function (switch between program P
A
and P
B
).
------- Function activated.
------- Function deactivated.
Pulse arc welding process (program P
START
)
The pulse arc welding process can be activated in the start program (P
START
) with the
special non-latched and special latched operating modes.
------- Function activated.
------- Function deactivated.
