Quick overview
System (main menu)
28
099-00L200-EW501
13.05.2022
Save (USB)
JOB range
Filename
Start
Safely remove the USB flash drive
Load (USB)
Filename
JOB range
Start
Safely remove the USB flash drive
4.7.6 Service
Service
Contacting
EWM-AG
Searching for a dealer
Screenshot
Advanced settings
Warnings
Fuse protection warning
Dynamic power adjustment
Software update
Reset
Factory settings
Advanced (service area)
4.7.7 Parameter overview
Display
Setting/selection
Power source menu
Switch ignition mode
------- HF ignition
------- Liftarc
HF intensity
------- Standard: Maximum value for the high-voltage ignition pulse Up
------- Reduced: Reduced value for the high-voltage ignition pulse Up
Re-ignition after arc interruption
> see 5.1.6.3 chapter
------- JOB-dependent time (ex works 5 s).
------- Function disabled or numerical value 0.1–5.0 s.
Reconditioning pulse (tungsten ball stability)
1
Cleaning effect of the tungsten ball at the end of welding.
------- Function enabled (ex works)
------- Function disabled