Functional characteristics
Managing welding tasks (JOB manager)
099-00L200-EW501
13.05.2022
65
5.5 Managing welding tasks (JOB manager)
Selection
JOB
Figure 5-52
5.5.1 Copying welding tasks (JOB)
Use this function to copy the JOB data of the currently selected JOB to a target -JOB to be specified.
Selection
JOB manager
Copy
5.5.2 Reset welding task (JOB) to the factory setting
This function resets the JOB data of a welding task (JOB) to be selected to the factory settings.
Selection
JOB manager
Reset
5.6 Power-saving mode (Standby)
The power-saving mode can be enabled by either pressing and holding the System push-button or by
setting an adjustable time parameter in the energy-saving function sub-menu.
By pressing and holding the System push-button again, the machine will switch back to a state ready
for welding.
Selection
System settings
Power source
Energy saving function
Standby time