Figure 1 Figure 2
Figure 3
4. Apply teflon tape to the male thread of RO storage tank, install the plastic ball valve
and tighten it onto the storage tank. (See figure 4)
5. Connect one end of PE pipe to inlet ball valve, connect the other end to the inlet of
filter machine. (See figure 5)
6. Connect one end of PE pipe to “connect the pressure storage tank” of filter machine,
connect the other end to the ball valve on storage tank. (See figure 6)
7. Connect one end of PE pipe to the outlet for drain water of filter machine, put the other
end to the drain. (Do not block this end of pipe)
Pipe Installation 2
Connect filter machine using self-piercing saddle valve
－
3/8”,1/2”copper pipe installation:
1. Shut off the water supply;
2. Connect the pipe using self-piercing saddle valve and tighten
them;
3. Tighten the handle and pierce the pipe.
4. Loosen the handle. (Make sure there is no leakage around the
saddle valve)
5. Connect the other end using PE pipe connect to the inlet of filter
machine.
6. Apply teflon tape to the male thread of RO storage tank, install
the plastic ball valve, using the PE pipe to connect plastic ball valve
to filter machine.
7. Locate the position for drain saddle fixing, drain a hole sized
around 1/4” to 3/8” on the drain pipe, make the hole in line with the
guide hole of drain saddle.
8. Fix the drain saddle onto the drain pipe and connect to the
“concentrated water” on the filter machine using PE pipe.
Note: The specific installation is based on the spare parts you have.
6
