NL
FR
EN
NL
www.ewt-france.com
www.ewt-france.com
13
circulation of air around the
appliance.
• DO NOT BLOCK THE
VENTILATION! Regularly check
that the air intakes and outlets
are not obstructed.
• Do not put any objects through
the protective grill (finger, pen,
tool…)
• Never use the appliance if the
protective grills are not fitted in
compliance with the assembly
instructions.
• Do not remove the protective grill
for cleaning.
• Do not place the air intake
close to walls or curtains (1m).
Obstruction of the air flow may
reduce the appliance’s efficiency.
SPECIFICATIONS
Model
VENTILEC
Number of speed
3 – Low, Medium, High
Pre-programmed modes
Yes – Normal, Natural, Sleep
Oscillation
Yes
Tilt adjustement
Yes : manual
Timer
Yes : 1 – 2 – 4 – 8H
Digital display
Yes – LED screen
Remote control
Yes
Number of blades
5
Power
50W
Voltage
220 - 240 V~
Frequency
50 HZ
Product dimensions (LxWxH)
L45 x W40 x H130
Product weight
7.2kg
ASSEMBLY
Step 1
Firstly, place the latch (1) onto a
level area of floor, and insert it into
the centre of the fan stand (2).
Step 2
Secure by firmly screwing the
L-screw onto the top of the latch
(1).
Step 3
Place the whole of the motor (4-8)
on the top of the fan stand (2) and
screw the clamping nut (3) firmly
into place.
Step 4
Attach the back fan guard (9) to
the motor, lining up the holes in the
guard with the front motor protector
(8).Secure it by firmly tightening the
back fan guard safety nut (12).
Step 5
Then put the fan blades (11) into
place and attach them using the
blades safety cap (13), turning it
anticlockwise.
Attach the front fan guard (15) to
the back fan guard (9). To do so, use
both hands to press the two guards
together and ensure that they are
fully clipped together and lined up
with the fan guard belt (10). Then
attach it all together by tightening
the clasp located on the front fan
guard (15).
Step 6
Once the appliance has been
correctly assembled, use it by
following the instructions set out
below.
INSTRUCTION FOR USE
1. Please read these instructions carefully before using the
appliance and keep them in case of future use.
2. Make sure that the voltage of your local electricity network
corresponds to the one which appears on the appliance.
3. Before using it for the first time, remove the appliance’s
protective tabs and stickers.
Place your appliance on a flat floor and plug the appliance
into the electrical supply (220-240V, 50Hz) using the electrical
cable.
A. Appliance On/Off
B. Timer control
C. Speed control
D. Ventilation mode control
Ventilec.indd 13
28/11/18 15:30
