NX1200 User Guide
© 2014 ExaDigm, Inc.
Page 15 of 16
Rev. 1/0614
Replace the battery only with another battery that has been qualified with the unit. Use of an
unqualified battery may present a risk of fire, explosion, leakage, or other hazard.
Promptly dispose of used batteries in accordance with local regulations.
Children should not touch battery and charger.
Avoid dropping the battery and charger. If the battery or charger is dropped, especially on a hard
surface, and the user suspects damage, contact ExaDigm for inspection.
Improper battery or charger use may result in a fire, explosion, or other hazard.
18.0
Regulatory Notices and Certifications
18.1
Part 15 of FCC Rules
FCC Part 15 Class B Digital Device
The NX1200 has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Operation of the NX1200 in a residential installation, per Part 15 of the FCC rules, is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. The device must accept any interference received, including interference that may cause undesired
operation.
18.2
Part 68 of FCC Rules
This equipment complies with the regulations in Part 68 of the FCC Rules. The FCC registration number
and REN (ringer equivalence number) is located on the FCC label located in the back of the terminal.
The REN is used to determine the quantity of devices that may be connected to the telephone line.
Excessive RENs connected to the telephone line may result in the device not being able to communicate.
Contact the telephone company to determine the maximum RENs for the calling area.
This equipment cannot be used on telephone company provided coin service. Connection to Party Line
Service is subjected to state/local fees.
The equipment uses RJ11C jacks.
