NX1200 User Guide
© 2014 ExaDigm, Inc.
Page 16 of 16
Rev. 1/0614
The equipment is provided with a FCC compliant telephone cord and modular plug. It is designed to
connect to a standard telephone network jack or compatible modular jack that is Part 68 compliant.
If this equipment causes harm to the telephone network, the telephone company will notify you in
advance of a disruption of service. If advance notice is not possible then the telephone company will
notify you as soon as possible. You will be advised of your right to file a complaint with the FCC if you feel
it necessary.
The telephone company may make changes to their facilities, equipment, operations, or procedures that
could affect the connection of the equipment. If changes are occurring the telephone company will
provide advance notice to allow for time to modify the equipment’s connection access to maintain
uninterrupted service.
If the equipment malfunctions notify ExaDigm Inc for repair and/or warranty information. If the equipment
is causing trouble to the telephone network connection the telephone company may request the
equipment to be discontinued until the problem is resolved. Customers are not to attempt to fix the
equipment on their own.
ExaDigm Inc recommends connecting the equipment to an AC surge protector to avoid damage to the
equipment in the event of electrical surges.
To reduce the risk of fire use only a No. 26 AWG or larger telecommunication line cord.
18.3
UL Standards
Follow the instructions below for Replaceable Batteries:
"CAUTION: Risk of Explosion if Battery is replaced by an Incorrect Type.
Dispose of Used Batteries According to the Instructions."
Follow the general "IMPORTANT SAFETY INSTRUCTIONS when using your telephone equipment, basic
safety precautions should always be followed to reduce the risk of fire, electric shock and injury to
persons, including the following:
Do not use this product near water for example, near a bathtub, washbowl, kitchen sink or laundry
tub, in a wet basement or near a swimming pool.
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a
remote risk of electric shock from lightning.
Do not use the telephone to report a gas leak in the vicinity of the leak.
Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire.
They may explode. Check with local codes for possible special disposal instructions.
SAVE THESE INSTRUCTIONS
Follow the instructions below for Telephone line cord safety:
"CAUTION: To reduce the risk of fire, use only No. 26 AWG or larger (e.g., 24 AWG) UL Listed or CSA
Certified Telecommunication Line Cord"
For other TNV accessibility "Disconnect TNV circuit connector before accessing other port" or equivalent.
