XD2000 Terminal User’s Guide
- 2 -
Rev.1/0506
Installing and Configuring
Follow the steps in order to use your terminal with your merchant account and begin accepting credit card
payments. If you require assistance with the process or need to find details regarding your accounts, please
contact your dealer.
Pre-Installation
Ensure that the terminal is properly connected to an active power source or with a fully charged battery in it.
Carefully plug the AC adapter into the terminal (the plug should insert into the power receptacle on the right side
of the terminal) and secure it to a live electrical outlet.
Follow instructions for your specific module type:
Combo Modem (Ethernet, Dial-Up, Host USB)
1.
Note:
Make sure to insert the Internet cable into the jack
BEFORE
you turn on the terminal.
2.
Option only for live transactions
– Connect the terminal to an active Internet cable. Insert the Internet
cable into the jack located in the rear of the terminal.
Important note:
Press ENTER after every selection.
a. Admin
b. Setup
c. Password: 1234
d. Communication
e. Ethernet
f. Conn.
Method
g. Choose whether it’s going to be a Static/DHCP/PPPoE
Connection
h. Set
IP
(If DHCP/Dynamic press cancel and proceed to step ‘o’)
i. Set
Mask
j. Set
Gateway
k. Set
DNS1
l. Set
DNS2
m. Review all info for Static IP and press cancel after each viewing
n. Press CANCEL twice to return to the ETHERNET MENU
o. Scroll down to Test Connection and press enter
p. Go back to Main Menu and Process Transactions
To Switch from Ethernet to Dial-Up use the following procedures:
a. Admin
b. Setup
c. Password: 1234
d. Communication
e. Modem
Std
f. Cancel to setup
g. Select [Processor Name]
h. Comm
Option
i. Direct
Call
j. Cancel to Main Menu and run a test transaction
-or-
a. Main
Menu
b. Change
Modem
To Switch to USB mode:
Please contact Technical Support at (866) 392-8326 (option 1) because USB connection options vary from
product to product.
