XD2000 Terminal User’s Guide
- 4 -
Rev.1/0506
GSM Modem
Setting up network service for GSM/GPRS (Cingular or T-Mobile)
Before you could use our terminal to do live transactions with TCP/IP connections, you need to make sure the
modem is activated by inserting in the SIM card.
The following is the procedure to activate the Modem:
a. Contact your network carrier and obtain a SIM Card by applying
for an account that is for Data Network (GPRS)
**Note:
Your local store may not know what you are trying to do,
so to make things simple state that you need a SIM Card for
your Laptop Air Card (PCMCIA CARD)
b. Remove back sliding tray from Module by pushing on the right
corner tab
c. Place SIM Card onto tray
d. Slide tray back into Module
e. Use the following steps to activate card
f. Admin/ Setup/ Password : 1234/ Communication/ GSM/ GSM
Carrier/ Select Carrier/Cancel To GSM Menu/ Initialize/ Test
Connection/ 0% packet loss is good/ Cancel out to Main
g. Run Test transaction
Global Dial-Up Modem
If you have a Dial-Up Terminal, your terminal should be configured and ready to go but in order to make sure
everything is set up properly, use the following steps.
a. Make sure the phone line is properly secured to the back connector.
b. Power up terminal by holding down the power button 3 seconds
c. Run a test transaction
d. If you should encounter a Connection Error, check the following:
e. Make sure the phone line is connected
f. Admin
g. Setup
h. Password: 1234
i. Communication
j. Make sure Modem Std has a star next to it, if not press enter at this option
k. Cancel out to Main
l. Run test transaction again.
m. If you see a connection error, please contact Technical support at 1-866-392-8326
