brine tank at this time.
E] Place the water softener in by-pass position. Turn on the main water supply to the water
softener. Open a cold soft water faucet close to the water softener and let it run a few
minutes or until the water softener is free from foreign material such as piping solder that
may have resulted from the installation of the water softener.
F] Place the water softener bypass in service postion.
G] Manually index the water softener control valve into “service” position and let the water
flow into water softener mineral tank. When the water softener water flow stops, close
the water softener inlet valve, place the water softener control valve in “backwash”
position to relieve head of air pressure, then gradually open inlet water softener valve to
purge remaining air in water softener mineral tank. Return water softener control valve to
“service” position.
H] Electrical:
All water softener electrical connections must be connected according to codes. Use
electrical conduit if applicable. Plug water softener into power supply.
2
Summary of Contents for Superflow Series
