Excalibur AL-1775-3DB, Operation Manual

Installer Programmable Features (cont’d)

Feature #5 - Light Relay Function (3DB) / Sat. Port Green Wire Function (non-3DB)

Dome Light Output  (press LOCK to program) 

Start       (press 

UNLOCK 

to 

program) 

Ignition Output      (press TRUNK to program)

Accessory Output   (press START to program)

Status 

      (press 

LOCK 

& 

UNLOCK 

to 

program)

Light Flash         (press TRUNK & START to program)

This output can be programmed to perform any functions listed above 3DB models 

utalize a built in relay Non-3DB models use a 250ma negative output on the satalite port

Feature #7 - Starter Cranking Time

0.75 Second  (press LOCK to program) 

1.00 Second  (press UNLOCK to program)

1.5 Seconds  (press TRUNK to program)

2.25 Seconds (press START to program)

3 Seconds 

(press LOCK & UNLOCK to program)

Average   

(press TRUNK & START to program)

This feature determines the crank time of the 1st start attempt when in “Tachless” mode 

If the engine doesn’t start on the first attempt, it will retry up to 3 more times extending 

the crank time by an additional 02 second with each attempt The “Average” setting will 

sample the last 8 cranks (by ignition key) and average the crank time automatically for 

increased accuracy

Feature #8 - Door Lock/Unlock Outputs     

0.8 Second Outputs          (press LOCK to program) 

3 Second Outputs            (press UNLOCK to program)

Double Pulse Unlock Output  (press TRUNK to program)

Total Closure Lock Output    (press START to program)

This changes the system’s doorlocking outputs to suite different vehicle requirements The 

total closure setting provides a 28 second lock pulse (press LOCK or UNLOCK is during 

the pulse to stop it)  and a 08 second unlock pulse

Feature #9   Remote Start Lock Control

Off 

        (press 

LOCK 

to 

program) 

Lock 

After 

Start 

     (press 

UNLOCK 

to 

program)

Unlock Before start 

(press TRUNK to program)

Unlock Before Start & Lock After Start 

(press START to program)

Lock After Engine Off   

(press LOCK & UNLOCK to program)

This feature allows for OEM alarm/lock control in relation to remote start operations thus 

eliminating extra wiring for OEM alarm control

Feature #6  Blue Satellite Port, Blue Wire Function

Ignition   

(press LOCK to program) 

Status / GWR  

(press UNLOCK to program) 

Defrost 0.8 sec Pulse  (press TRUNK to program)

Defrost 10 min Pulse  (press START to program)

Pulse After Engine Off  (press LOCK & UNLOCK to program)

Horn 

(press TRUNK & START to program)

This determines the function of the Blue wire on the Blue satellite relay port

The Status setting turns on briefly before the Ignition output and stays on during remote 

start mode The other pulse settings give a 08 second pulse under the selected condi-

tion 

Defrost Pulse

 will send a pulse after start only when the cabin temperature is below 

freezing (32 degrees F / 0 degrees C) 

20