Excalibur AL-1775-3DB, Operation Manual

Installer Programmable Features (cont’d)

Feature #11 - Manual Transmission Reservation Mode

On      (press LOCK to program)

Off      (press UNLOCK to program) 

This feature changes the parameters of the system’s remote start operation to be suitable 

for manual transmission-equipped vehicles via a “setup” procedure which must be fol-

lowed upon exiting the vehicle to ensure the transmission is in neutral

Feature #10 - Turbo Timer

Off      (press 

LOCK 

to 

program) 

Run 1 Minute    (press UNLOCK to program)

Run 2 Minutes  (press TRUNK to program)

Run 3 Minutes  (press START to program)

This feature, the operation of which is described on page 8, when turned on 

configures the system to automatically keep the engine running briefly after the key is 

turned off.  This operation is designed specifically for vehicles with turbocharged engines. 

NOTE: This feature is dependent on the proper wiring of the neutral safety circuit.

Feature #12   Data Port Protocol

Green: DBI, Black: DBI   

(press LOCK to program) 

Green: iData, Black: iData  (press UNLOCK to program) 

Green: DBI, Black: iData 

(press TRUNK to program)

Green: iData, Black: DBI 

(press START to program)

This feature determines which data protocol is used on each data port Choose this based 

on the accessory being connected to the port 

NOTE: When a BLADE is inserted, this 

feature automatically switches the black port to the iDatalink protocol.

Feature #14 - Pulse Ignition On Disarm

On      (press LOCK to program)  

Off      (press UNLOCK to program) 

This feature will pulse the ignition and activate any attached immobilizer bypass module 

for vehicles that require the ignition to be turned on to disarm the OEM alarm

Feature #15   Lock On Prewarn

On  (press LOCK to program)  

Off  (press UNLOCK to program)

This feature will automatically lock the doors to combat unauthorized entry from lock pick-

ing when the prewarn zone is triggered 

Feature #16 - Starter Interrupt Functions

Alarm Only         (press LOCK to program)

Anti-Grind Only      (press UNLOCK to program) 

Alarm & Anti-Grind  (press TRUNK to program) 

Automatic     (press 

START 

to 

program)

Alarm Only 

- The Starter Interrupt is operable whenever the alarm is armed  

Anti-Grind Only -

  The Starter Interrupt is operable whenever remote start is on 

Alarm & Anti-Grind - 

This setting engages starter interrupt when the alarm is armed AND 

when the system is in remote start mode 

Automatic 

- The Starter Interrupt output will automatically engage 90 seconds 

after the ignition switch is turned “off”, and after disarming the system

Feature #13 - Alarm Functions 

On                 (press LOCK to program)  

Off                 (press UNLOCK to program) 

Off- Unlock Only  (press TRUNK to program)

Sensor Detect     (press START to program)

This feature converts keyless entry models to full alarm systems (installation changes may 

be required) 

Sensor Detect

 automatically turns on alarm functions when a sensor is con-

nected to the sensor port or data port

21