21
Feature #6 - Engine Detection method
Tachless hi
(press “
arm/lock
” button to program)
- DEFAULT
Tachless Lo
(press “
disarm/unlock
” button to program)
Tach Wire
(press “
trunk
” button to program)
Data Tach
(press “
start
” button to program)
Crank Only
(press “
lock
” & “
unlock
” to program)
This feature selects the method in which the remote start monitors the engine’s running condition
in remote start mode
“Tachless hi”
sensitivity mode has an associated base starter output time duration (see installer
feature #7) and monitors the vehicle’s voltage level to determine if the engine is running. This set
-
ting looks for a voltage increase of 0.3v after cranking.
“Tachless Lo”
sensitivity mode operates like the “Tachless Hi” setting but looks for a voltage
increase of 0.5v after cranking.
“Tach Wire”
Before this setting is programmed, refer to the “Violet/White wire” section of the
installation manual for proper wiring connection and the Tach Learn Procedure. It will crank the
engine for up to 3 seconds or until a tach signal is detected.
“Data Tach”
mode operates just like the “Tach Wire” setting except it takes its reading from the
D2D data port instead of using the Violet/White wire. Before using, make sure this function is sup
-
ported by the Databus Interface module.
“Crank Only”
AKA “blind start” is similar to the “Tachless” settings however, it only makes one
start attempt and does not monitor engine running conditions. This is useful for many “push-to-
start” vehicles
installer Programmable Features (cont’d)
Feature #8 - PinK/WhiTE (iGn #2)Wire Function
ignition
(press “
arm/lock
” button to program)
- DEFAULT
Accessory
(press “
disarm/unlock
” button to program)
Starter
(press “
trunk
” button to program)
This feature changes the operation of the unit’s large PINK/WHITE output wire.
This feature
should only be programmed by the installer
Feature #7 - Extended Starter Cranking Time
0.75 Second
(press “
arm/lock
” button to program)
- DEFAULT
1.00 Second
(press “
disarm/unlock
” button to program)
1.5 Seconds
(press “
trunk
” button to program)
2.25 Seconds
(press “
start
” button to program)
This feature determines the crank time of the 1st start attempt when in “Tachless” mode. If the
engine doesn’t start on the first attempt, it will retry up to 3 more times extending the crank time by
an additional 02 second with each attempt
Feature #9 - Arm, Disarm or Additional Channels
Arm / Disarm
(press “
arm/lock
” button to program)
- DEFAULT
Arm / Channel 5
(press “
disarm/unlock
” button to program)
Channel 4 / Disarm
(press “
trunk
” button to program)
Channel 4 / Channel 5
(press “
start
” button to program)
The system has outputs designed for arming and/or disarming a factory-equipped security system.
These wires may be used instead to provide further system outputs, which are remotely operated
by the controller or transmitter These outputs are in addition to the 2nd channel and 3rd channel
outputs As shown in the programming assignment, the arm, disarm, channel 4 and channel 5 are
programmable as various combinations. For example, if the disarm output is needed, but not the
arm output, then channel 4 may be made available for use.
