25
Installer Programmable Features (cont’d)
Feature #11 - Manual Transmission Reservation Mode
On (press LOCK to program)
Off (press UNLOCK to program)
This feature changes the parameters of the system’s remote start operation to be suitable for
manual transmission-equipped vehicles via a “setup” procedure which must be followed upon exit
-
ing the vehicle to ensure the transmission is in neutral�
Feature #10 - Turbo Timer
Off (press
LOCK
to
program)
Run 1 Minute (press UNLOCK to program)
Run 2 Minutes (press TRUNK to program)
Run 3 Minutes (press START to program)
This feature, the operation of which is described on page 8, when turned on configures the system
to automatically keep the engine running briefly after the key is turned off. This operation is
designed specifically for vehicles with turbocharged engines.
NOTE: This feature is dependent on the proper wiring of the neutral safety circuit.
Feature #12 Data Port Protocol
Green: DBI, Black: DBI
(press LOCK to program)
Green: iData, Black: iData (press UNLOCK to program)
Green: DBI, Black: iData
(press TRUNK to program)
Green: iData, Black: DBI
(press START to program)
This feature determines which data protocol is used on each data port� Choose this based on the
accessory being connected to the port�
NOTE: When a BLADE is inserted, this feature auto-
matically switches the black port to the iDatalink protocol.
Feature #13 - Alarm Functions
On (press LOCK to program)
Off (press UNLOCK to program)
Off- Unlock Only (press TRUNK to program)
Sensor Detect (press START to program)
This feature converts keyless entry models to full alarm systems (installation changes may be
required)�
Sensor Detect
automatically turns on alarm functions when a sensor is connected to
the sensor port or data port�
Feature #14 - Pulse Ignition On Disarm
On (press LOCK to program)
Off (press UNLOCK to program)
This feature will pulse the ignition and activate any attached immobilizer bypass module for
vehicles that require the ignition to be turned on to disarm the OEM alarm�
Feature #15 Lock On Prewarn
On (press LOCK to program)
Off (press UNLOCK to program)
This feature will automatically lock the doors to combat unauthorized entry from lock picking when
the prewarn zone is triggered.
Feature #16 - Starter Interrupt Functions
Alarm Only (press LOCK to program)
Anti-Grind Only (press UNLOCK to program)
Alarm & Anti-Grind (press TRUNK to program)
Automatic (press
START
to
program)
Alarm Only
- The Starter Interrupt is operable whenever the alarm is armed�
Anti-Grind Only -
The Starter Interrupt is operable whenever remote start is on�
Alarm & Anti-Grind -
This setting engages starter interrupt when the alarm is armed AND when
the system is in remote start mode�
Automatic
- The Starter Interrupt output will automatically engage 90 seconds after the
ignition switch is turned “off”, and after disarming the system�
