9
OPTIC EXCALIBUR
English
CONNECTION OF THE TOOLING TO THE POWER SUPPLY
•
Check the switch (
F4
) is on the “
OFF
”
(0)
position before
connecting the cable to the mains.
•
Place the pressure control knob (
F5
) on the “
MIN
” position
(turn counterclockwise)
.
Should anyone use an extension cable between
the tooling and the socket, it must have the same
characteristics as the cable supplied
(minimum
diameter of the wire 2.5 mm
2
)
with a maximum
length of 50 mt. Higher lengths and lower diameters
can provoke excessive voltage falls and also an
anomalous working of the equipment
•
Lift the suction pipe and dip it into the solvent tank.
•
Ensure the gun (
F3
) is without nozzle.
•
Press the switch (
F4
) of the equipment
“ON”
(I)
.
•
Turn clockwise the pressure control knob (
F5
) so as the
machine works at idle speed.
WASHING OF THE NEW EQUIPMENT
•
The equipment has already been adjusted at our factory with
light mineral oil left inside the pumping group as protection.
Therefore, wash with diluent before sucking the product.
F4
OFF
F5
F3
F4
F5
ON
Summary of Contents for Larius
Page 2: ......