26
OPTIC EXCALIBUR
English
•
Put liquid Tefl on on the fi rst two turns (
N31
) and (
N32
) to avoid
the two components coupled as shown from unscrewing.
•
Use a 36 mm spanner to screw on the pump unit
(
N10
).
•
Make the piston stem (
N19
) fi tted previously complete a full
stroke as shown.
•
Use the pin (
N12
) supplied to tighten the gasket compression
ring nut (
N11
).
Close this until it is fully touching, without forcing.
CORRECT POSITIONING OF THE PUMP UNIT
Once the unit has been refi tted, proceed as follows:
•
Check the position of the con rod, which should be positioned
at its lower stopping point.
•
Put the entire pump unit (
N10
) inside the reduction cover
(
N33
) as shown.
N32
N31
N10
N19
N11
N12
Summary of Contents for Larius
Page 2: ......
