8
COmBinaTiOn inDiCaTiOnS:
FaST aLTernaTeS green/reD:
System locked w/ remote start activated.
The Status Light (cont’d)
Standard programming:
Before you begin, have all transmitters which are to operate the system.
Step 1
Then, turn the ignition “on”.
Step 2
Within 5 seconds of Step 1, press the Valet Switch 5 times. The antenna will beep, confirming
that the system is ready to learn a transmitter code.
Step 3
Press the button on each transmitter one at a time. The antenna will beep once to confirm
that each transmitter was learned. If a code is not received within 10 seconds of Step 2, the learning
process will automatically exit.
programming Transmitters
Step 1
Turn the ignition key “ON”, then “OFF”
Step 2
Within 5 seconds of step 1, press the valet switch 5 times to access user features.
~ The antenna will beep and the status light will turn on.
Step 3
Within 10 seconds of step 2, press the valet switch the number of times corresponding with
the desired feature’s number.
~ The antenna will beep, equal to the selected feature.
Step 4
NOTE: On some vehicles, it may be necessary to turn the ignition on at this point to power the brake circuit.
Change the feature by pressing the brake pedal equal to the desired setting. The antenna will beep to
correspond with the chosen setting.
programming Features
