Excalibur RS-270, Operation Manual

If the Unauthorized Transmitter Alert feature is on, programming a transmitter to the 

system will activate the “UTA” warning and the extended Status Light indication� For the 

next 48 hours, the siren/horn will sound a brief series of chirps every time the vehicle’s 
ignition key is turned on� 

Special Programming procedure to turn on the UTA feature:  

Use this method to 

program transmitters or optional controllers, and to turn on the Unauthorized Transmitter 

Alert feature�

  Follow the same steps as the Standard Programming, but on any controller being 

programmed instead of pressing  the 

LOCK/UNLOCK

 button, press the 

LOCK/UNLOCK

and the

 START

 buttons together�   This action turns 

on

 the Unauthorized Transmitter Alert 

feature and at the same time programs the controller to operate the system�

  Once the Unauthorized Transmitter Alert feature is turned on, the warning will sound 

for 48 hours after any transmitter programming, including the programming session which 

was used to turn it on� This feature can only be turned off again by sending the system 

back to Omega for a reset�

Step 1

  Turn the ignition key “ON”, then “OFF”�

Step 2

  Within 5 seconds of step 1, press the valet switch 5 times to access user features 

(10 times to access installer features)�

  ~ The siren/horn will sound and the status light will turn on�

Step 3

  Within 10 seconds of step 2, press the valet switch the number of times corre-

sponding with the desired feature’s number�

  ~ The siren/horn will chirp, the status light, and the parking lights will flash equal 

  to the selected feature�

Step 4

  Change the feature by pressing the transmitter button that corresponds with 

the desired setting� The siren/horn will chirp to correspond with the chosen setting�

Programming Features

Standard Programming:  

Using this method to program additional or replacement 

transmitters does not turn on or otherwise affect the Unauthorized Transmitter Alert (UTA) 

feature� Before you begin, have all transmitters which are to operate the system at hand� 

Step 1 

Then, turn the ignition “on”�

Step 2 

Within 5 seconds of Step 1, press the Valet Switch 5 times� The siren/horn will 

briefly sound, confirming that the system is ready to learn a transmitter code. 

Step 3 

Press the START button on each transmitter one at a time� The system will chirp 

the siren/horn once to confirm that each was learned. If a code is not received within 10 

seconds of Step 2, the learning process will automatically exit� 

Programming Controllers/Transmitters

11