5
Controlling The System (cont’d)
TRUNK RELEASE/ CHANNEL 2:
Press and hold the
“TRUnK” button for 3 seconds.
THE TRUnK wILL OPEn, THE DOORS wILL
•
UnLOCK, THE PARKInG LIGHTS wILL FLASH
TwICE THEn ILLUMInATE FOR 30 SECOnDS,
AnD THE HORn wILL HOnK TwICE.
SILENT LOCK/UNLOCK
•
: PRESS THIS BUT-
TOn TwICE wITHIn 5 SECOnDS TO LOCK
OR UnLOCK THE DOORS wITHOUT HORn
HOnKS.
REMOTE START:
Press and release the “START” button
twice. (see installer feature #1 for other options)
THE PARKInG LIGHTS wILL FLASH AnD
•
THE STATUS LIGHTS wILL FLASH RAPIDLy.
THE IGnITIOn wILL TURn On AnD THE
•
SySTEM wILL START THE EnGInE.
wHEn THE EnGInE IS RUnnInG, THE
•
STATUS LIGHTS wILL FLASH SLOw AnD THE
PARKInG LIGHTS wILL STAy On AS LOnG AS
REMOTE START MODE IS ACTIVE.
If the engine stalls, the system will make up to 3 more attempts.
•
Each time you park your vehicle, set the climate controls to give
•
you the desired interior temperature when you use the remote start.
The engine will run for the preset run time (see user feature #1).
•
Run Time Extender
•
: Press the “START” button one time while in
remote start mode to restart the engine run timer.
NOTE: This can only be used once per remote start cycle. If the system has
an ECHO 2-way upgrade, you will get “run time expiration” warning chirps 1
minute before the timer ends.
If you decide not to drive your vehicle, you can turn off the remote
•
start using the same method to turn it on (keep in mind that the first
press is considered the
Run Time Extender
).
Upon entering the vehicle during remote start mode, turn the igni-
•
tion key to the “On/RUn” position (
NOT START!!
). when you press
the brake pedal, the remote start will turn off.
