Installer Programmable Features (cont’d)
Feature #11 - manual Transmission mode
On
(press “
lock
” button to program)
Off
(press “
unlock
” button to program)
- DEFAULT
This feature changes the parameters of the system’s remote start operation to be suitable for
manual transmission-equipped vehicles via a “setup” procedure which must be followed upon exit
-
ing the vehicle to ensure the transmission is in neutral�
Feature #12 Data Port Protocol
Green: DBI, Black: DBI
(press “
lock
” button to program)
- DEFAULT
Green: iData, Black: iData
(press “
unlock
” button to program)
Green: DBI, Black: iData
(press “
trunk
” button to program)
Green: iData, Black: DBI
(press “
start
” button to program)
This feature determines which data protocol is used on each data port� Choose this based on the
accessory being connected to the port�
Feature #13 - Virtual Alarm
On
(press “
lock
” button to program)
Off
(press “
unlock
” button to program)
- DEFAULT
This feature converts the system into a Security/Remote Start System by enabling antitheft alarm-
oriented operations and features�
OPTIONAL MODULES MAY BE REQUIRED.
Feature #14 - Pulse Ignition On Disarm
On
(press “
lock
” button to program)
Off
(press “
unlock
” button to program)
- DEFAULT
This feature will pulse the ignition and activate any attached immobilizer bypass module for
vehicles that require the ignition to be turned on to disarm the OEM alarm.
Feature #15 Lock On Prewarn
On
(press “
lock
” button to program)
- DEFAULT
Off
(press “
unlock
” button to program)
This feature will automatically lock the doors to combat unauthorized entry from lock picking when
the prewarn zone is triggered�
AN OPTIONAL SENSOR IS REQUIRED.
Feature #16 - Starter Interrupt Output Functions (EDP+ models Only)
Alarm Only
(press
“
lock
” button to program)
Anti-Grind Only
(press
“
unlock
” button to program)
- DEFAULT
Alarm & Anti-Grind
(press “
trunk
” button to program)
Automatic
(press
“
start
” button to program)
Alarm Only
- The Starter Interrupt is operable whenever the alarm is armed�
Anti-Grind Only -
The Starter Interrupt is operable whenever remote start is on�
Alarm & Anti-Grind -
This setting engages starter interrupt when the alarm is armed AND when
the system is in remote start mode� This prevents the starter from grinding if the user accidentally
turns the key to “START” during remote start�
Automatic
- This will cause the Starter Interrupt output to automatically engage 90 seconds after
the ignition switch is turned “off”, and after disarming the system�
Feature #17 Low Temp Crank Extender (EDP+ models Only)
0ms (Off)
(press “
lock
” button to program)
200ms
(press “
unlock
” button to program)
- DEFAULT
300ms
(press “
trunk
” button to program)
400ms
(press “
start
” button to program)
When the vehicle’s interior temperature is below freezing, this feature adds extra crank time to the
base timing (see installer feature #7)� It applies to tachless modes only (installer feature #3)�
17
Summary of Contents for RS-360-EDP
Page 14: ...Blank Page 14 ...
Page 18: ...Blank Page 18 ...
Page 20: ...Back Cover Color cover is in a separate file 20 ...