Excalibur RS-360-EDP, User Manual

Transmitter Functions (cont’d)

AUXILIARY FUNCTIONS 1-4

:

The actual operation of these functions will vary from car to car� They are designed to operate 

extra functions like automatic sliding doors or motorized hatches� Aux 1-4 are virtual outputs only 

available when this system is integrated with the vehicle’s data network� Consult with your installer 

to find out if any of these functions are available, then confirm each operation and write them 

below�

- 

Auxiliary 1 Function (___________________)

: To activate this function, press and release the 

“

trunk

” and “

start

” buttons simultaneously)� 

- 

Auxiliary 2 Function (___________________)

: To activate this function, press and release the 

“

lock

” and “

trunk

” buttons simultaneously)�

- 

Auxiliary 3 Function (___________________)

: To activate this function, press and release the 

“

unlock

” and “

start

” buttons simultaneously)�

- 

Auxiliary 4 Function (___________________)

: To activate this function, press and release the 

“

unlock

” and “

trunk

” buttons simultaneously)�

LOw BATTERY/LOw TEmP AUTOmATIC STARTING

Other Remote Start Features

TURBO TImER FEATURE

PIT-STOP FEATURE

  This feature allows you to leave your engine running for making quick errands. To use this fea

-

ture, have the engine running normally from the ignition switch and your foot off the brake pedal�  

Press the Valet Switch twice; the parking lights will flash and the horn chirps 5 times. Turn the key 

off and the engine will remain running for the programmed run time�

This is recommended for vehicles equipped with a turbocharger. It allows the engine to idle 

after driving to cool the turbo� When this Installer Programmable Feature (#10) is enabled, the 

system will automatically keep the engine running as follows:

•  With the engine running, hold the brake pedal and engage the parking brake.  

When the brake pedal is released, the system will keep the engine running for the programmed  

time (1, 2, or 3 minutes), and then automatically turn it off�  

•  The system may be locked while the engine is running.  Turbo Timer can be prevented from 

engaging, or “bypassed” if desired, by turning the engine off before engaging the parking brake�

NOTE: Temperature Related Features Are Only Available On EDP+ models.

  This feature will automatically start the engine if the vehicle battery drops below 11 volts or the 

interior temperature drops to 15 (or 32) degrees Fahrenheit� You must activate these features 

each time you park your car to use them� They can be activated one of two ways:

method 1 - Valet Switch

•  Turn the ignition switch “on”, then “off” (engine not running), and within 7 seconds press the 

valet switch twice�  If there is a 2 second delay without additional valet button presses, the horn 

will honk 3 times activating low voltage start mode� 

•  To activate low temp starting, enter low voltage start mode as described above but, immediate

-

ly after the horn honks, press the valet switch 1 time (15 degrees) or 2 times (32 degrees) within 5 

seconds. The horn will honk to confirm your selection.

method 2 - with The Controller (Low Volt + Low Temp - 15 Degrees Only)

•  Within 5 seconds of pressing LOCK, press the START button. You will get one chirp to confirm. 

NOTE:

 When low temp start mode is activated, low voltage start is also activated� These features 

will operate once every two hours until the ignition key is turned “ON”�

6