•
The top cover can then be lifted off, taking care not to misplace the rubber seal located around the base.
Oval port for uncut cable
•
To open
•
Pull the leaver upward to disengage the clasp then pull toward you.
•
Open the ring clasp and remove completely from the enclosure
•
Taking a cable with 180cm of cable jacket removed mid span, make a loop.
•
Feed the loop through the compression gland and rubber seal.
•
Feed the cable into the enclosure through the oval port.
•
Secure the cable ends to the internal cable clamp.
•
Secure the strength member to the end of the cable clamp.
•
•
If the oval port is not to be used insert the blanks provided
•
And seal with the compression gland as above
With the cable fully secured push the rubber seal into the oval port followed by the compression gland and tighten the
hexagonal bolts.
