14
ASSEMBLY
STEP 5
5a. Removing Hardware-
Remove eight
Bolts (23)
and eight
Washers (24)
from the
Back/Seat
Support Bracket (1)
and
Seat Sliding Tube (15).
Remove bolts with the
6mm Allen Wrench
provided.
5b. Installing the Seat Sliding Tube -
Insert the
Seat Sliding Tube (15)
into the
Bushings (54)
of
the
Rear Main Frame (3).
Attach the
Seat Sliding Tube (15)
to the
Back and Seat Support
Bracket (1)
with eight
Bolts (23)
and eight
Washers (24)
that were removed. Tighten bolts with
the
6mm Allen Wrench
provided.
5c. Instalilng the Handlebar
–
Attach the
Handlebar (13)
onto the
Back and Seat Support
Bracket (1)
with two
Bolts (70),
two
Curve Washers (25),
two
Washers (24),
and two
Cap Nuts
(32).
Tighten bolts with the
Multi Hex Tool with Phillips Screwdriver
provided. Connect the
Middle Section Hand Pulse Sensor Wires (55)
from the
Rear Main Frame (3)
to the
Hand Pulse
Sensor Wire (68)
from the
Handlebar (13).
HARDWARE PACK
Tool:
Multi Hex Tool with Phillips
Screwdriver
(70) Bolt
2 PCS
(25) Curve Washer
2 PCS
(24) Washer
2 PCS
(32) Cap Nut
2 PCS
6mm Allen Wrench
Summary of Contents for 900XL
Page 5: ...3 LABEL PLACEMENT...
Page 8: ...6 OVERVIEW DRAWING...
Page 11: ...9 HARDWARE TOOLS PACK...
