13
ASSEMBLY
STEP 3
3A.
Adjusting Seat Before Installing It:
The
Seat (6)
has 2 sets of adjustment holes. It is
recommended that users between
5’1” – 5’6”
use the holes towards the rear of the
Seat (6)
. It is
recommended that users between
5’7” – 6’3”
use the holes towards the front of the
Seat (6)
.
3B. Installing The Seat To The Seat Post:
Align the bolt holes on the underside of the
Seat (6)
with the holes on the plate at the top of the
Seat Post (5)
, then secure them together using three
Flat Washers (33)
, three
Spring Washers (102)
, and three
Hexagon Socket Bolts (58)
. Tighten
the
Bolts
(58)
with the
5mm Allen Wrench
provided.
3C. Installing The Seat Post & The Connection Wires:
Connect the
Connection Wire A (79)
from the
Seat Post (5)
to the
Connection Wire B (99)
from the
Front Frame (2)
as shown in
Figure D
. Insert the
Seat Post (5)
into the
Seat Post Plastic Bushing (12)
while being careful to
insert the wires without pinching them. Install the
Seat Adjustment Knob (14)
by turning it
CLOCKWISE, making sure that the
Seat Adjustment Knob (14)
catches one of the height
adjustment holes of the
Seat Post (5)
.
5mm Allen Wrench With
Phillips Screwdriver 1 PC
TOOL
(33) Flat Washer
3 PCS
(58) Hexa
g
on Socket
3 PCS
(102) Spring Washer
3 PCS
HARDWARE PACK
Summary of Contents for EXERWORK 1000
