Fault Location Tests
96
AXS-200/635
RFL Separate Good Pair (4 wire) Test
To set parameter values:
1.
To configure a section of cable for the test, press the up/down arrow
keys to highlight the section icon then press
to enable the section.
To disable a section, highlight the section icon then press
.
2.
Use the left/right arrow keys to highlight each parameter and press
to open the list or select the value.
3.
Press the up/down arrow key to highlight the desired value.
OR
Press the left arrow key to erase the existing value, and then use the
alphanumeric keypad to enter a value. To cancel the entry, press
.
4.
Press
to accept the value.
5.
Set other parameters as necessary.
6.
Configure other sections of the cable as required.
7.
Press
to start/stop the test.
