Connection Setup for DSL/IP Triple-Play Verification Tests
Copper, VDSL2, ADSL2+, and IP Triple-Play Test Set
143
Setup Line Connection
³
Subnet Mask
is the network address used to identify if the IP address is
within the same wide area network.
³
DNS1
is the address of the
primary
domain name server to be used by
the unit. If DNS is unavailable, enter 0.0.0.0.
³
DNS2
is the address of the
secondary
domain name server to be used
by the unit. If DNS is unavailable, enter 0.0.0.0.
Note:
WAN IP setup is not required when Access Mode is set to Bridged. The line
encapsulation setting defines the parameters required.
To select the WAN IP parameters to configure:
1.
From the
Connection Setup
pane, press the left/right function arrows
until the
WAN IP
tab is displayed.
2.
Press the F1, F2, or F3 key located just below the tab to select it.
3.
Press the up/down arrows to select the desired parameter.
4.
Press
to open the list or modify the parameter.
5.
In the list, press the up/down arrows to select the function or mode.
OR
Use the alphanumeric keypad to enter the value you want to specify.
6.
Press
to confirm the selection.
