Connection Setup for DSL/IP Triple-Play Verification Tests
148
AXS-200/635
Setup Line Connection
Down Stream Channels
The
Dwn Stream Chns
tab allows you
to enter values for
VPI
and
VCI
dependent on the number of enabled
down stream channels.The described
Selected Profile
is composed of the
current
LineMode
and
AccessMode
selections. If
LineMode
is set to
Ethernet
or
VDSL2
, this tab is
unavailable.
³
Downstream only channels #
is the number of downstream only
channels ranging from 0 through 7, with a default value of 0. When this
entry is set to 0, all
VPI
and
VCI
entries are unavailable.
³
VPI
is the virtual path identifier (VPI) ranging from 0 through 255 for the
downstream channel.
³
VCI
is the virtual circuit identifier (VCI) ranging from 32 through 65535
for the downstream channel.
To select the downstream channel parameters to configure:
1.
From the
Connection Setup
pane, press the left/right function arrows
until the
DwnStreamChn
tab is displayed.
2.
Press the F1, F2, or F3 key located just below the tab to select it.
3.
Press the up/down, left/right arrows to select the desired parameter.
4.
Press
to modify the parameter.
5.
Use the alphanumeric keypad to enter the value you want to specify.
6.
Press
to confirm the selection.
