CT440
17
3
Getting Started with Your CT440
Unpacking and Installing the CT440
The CT440 is designed for indoor use only, and is not dedicated to wet locations. It must be
operated under proper environment conditions, as explained in the following procedure.
You can use your CT440 as a benchtop instrument or mount it in a rack.
To unpack the CT440:
1.
Open the package with care and remove the protective foam.
2.
Set the CT440 on a flat stable surface free of excessive vibration.
3.
Do one of the following:
To use the CT440 as a bench-top instrument, set it on a flat stable surface free of
excessive vibration.
To install the CT440 in a 19-inch rack, follow the instructions detailed in
4.
Allow the flow of air to be pulled in freely from outside to inside the CT440 through the
air inlets located on the front panel and be pushed out the instrument through the
cooling fan grids on the rear.
5.
On the rear panel (see
on page 9), make sure the power switch is set to
O
.
C
AUTION
Make sure the location where the CT440 will be installed meets the environmental and
electrical characteristics listed in
I
MPORTANT
When unpacking, handle the device with care and do not damage the original
shipping container in case the CT440 needs to be returned to EXFO.
Summary of Contents for CT440 Series
