MaxTester DSL
9
3 Getting Started with the
MaxTester DSL Test Set
Turning the Unit On/Off
When you turn the unit on, you may use it immediately under normal conditions.
When the unit is turned off, it keeps the following parameters in its internal
memory:
³
Test parameters
³
User-defined thresholds
³
Regional, LCD, and energy-saving settings
³
Saved test results
There are two ways to turn off the MaxTester DSL Test Set
³
Suspend
: the next time you turn your unit on, you will quickly return to your
work environment.
³
Shutdown
: completely cuts power to the unit; the unit will perform a complete
restart routine the next time you use it. You should perform a shutdown if you do
not intend to use your unit for a week or more.
To turn the unit on:
Press and hold for ½ to 1 second to start. The unit initializes for a few seconds
and displays the Home pane.
To enter suspend mode:
Hold down the key until the suspend notification sound plays, about 1 second.
The MaxTester will stay in suspend mode for 2 hours. After which it will
automatically shutdown. This prevents complete battery discharge and ensures
maximum battery performance.
To perform a shutdown:
Hold down the key for about 4 seconds. The shutdown process starts.
Note:
In both previous cases, if the power adapter is plugged in, the unit will
enter a charge mode instead of suspending or shutting down.
