Creating and Starting a Test Case
88
IQS-8500 Series and IQS-8120NGE/8130NGE
Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test Set Test Cases
2.
For additional configuration parameters, refer to
3.
On the local module, press the
Start
button to start the test. The
Start
button will be available only when the connection between the two
IQS-8500 Series and IQS-8120NGE/8130NGE units is established.
At least one of the test procedures (For EtherSAM (Y.1564):
Service
Configuration Test
or
Service Performance Test
; For RFC 2544:
Throughput, Back-to-Back, Frame Loss or Latency) has to be enabled
to start the test. Test procedures that are enabled will be performed
following this order:
Service Configuration Test
and
Service Performance Test
for
E
therSAM (Y.1564)
Throughput
,
Back-to-Back
,
Frame Loss
, and
Latency
for
RFC 2544
.
4.
For additional results, refer to
