Creating and Starting a Test Case
Ethernet and Fibre Channel Application
93
Ethernet RFC 2544 Test Case
5.
Traffic stream configuration
5a.
For IPv4, select the
Automatic IP
Address
check box to dynamically
obtain an IP address from a DHCP
(Dynamic Host Configuration Protocol)
server or set the source and destination
IP addresses,
Subnet Mask
, and the
Default Gateway
. Refer to
information.
5b.
For IPv6, set the destination IP address
and if required, press the
IPv6 Config
button for additional IPv6 settings. Refer
to
page 487 for more information.
5c.
If required, set the network source MAC
Address. Select the
Resolve MAC
Address
check box or set the
destination MAC address. Refer to
on page 220 for more information.
5d.
Select the
Frame Format
. Choices are
Ethernet II
and
802.3 SNAP
. Refer to
for more information.
5e.
Set the
VLAN
parameters when required. Refer to
page 220 for more information.
5f.
Press
Finish
to complete the test setup. The
RFC 2544
’s
Global
tab is automatically displayed.
