Creating and Starting a Test Case
Ethernet and Fibre Channel Application
103
Ethernet Frame Analyzer Test Case
To create a Frame Analyzer test case:
1.
Test configuration:
1a.
Select
Ethernet 10/100/1000
or
Ethernet 10G
as the
Interface Type
.
Interface Type
is not available with
IQS-8510G.
1b.
For IQS-8510B: Select the
Topology
test
type:
Single Port
or
Dual Ports
.
1c.
Select
Frame Analyzer
as the
Application Type
.
1d.
Select the
IPTV
(Internet Protocol Television) check box to give
access to the IPTV testing capability.
IPTV
is a software option
available on IQS-8510B only and needs to be enabled to be
available (refer to
always performed on
Port 1
.
PBB-TE
and
MPLS
testing
capabilities are not available when the
IPTV
check box is selected
and vice versa. The
IPTV
check box is cleared by default.
1e.
Select the
Through Mode
check box to enable Ethernet
bi-directional in-line traffic monitoring between two end points in
a non-intrusive manner using both IQS-8510B test ports. Stream,
alarm and error generation as well as Ping and Trace Route
capabilities are not supported.
Through Mode
is a software
option available on IQS-8510B only and needs to be enabled to be
available (refer to
testing is only available in
Dual Ports
topology. The
Through
Mode
check box is cleared by default.
1f.
Press
Next
.
