Creating and Starting a Test Case
104
IQS-8500 Series and IQS-8120NGE/8130NGE
Ethernet Frame Analyzer Test Case
2.
Port configuration:
2a.
Select the port
Connector
Type (Optical
or
Electrical RJ-45
).
Optical
is automatically selected for the
Ethernet 10G
interface.
2b.
For IQS-8510B, select the
port number by pressing
on
Port 1
or
Port 2
.
Port 1
(IQS-8510B only) is
automatically selected
when
IPTV
is selected.
For IQS-8510B in
Dual
Ports
, select the first port
and proceed with the rest
of the configuration for the
first port. However, before
pressing
Finish
, press
Back
several times to return to the port setup window, select the
second port and proceed with the rest of the configuration for the
second port.
2c.
For Electrical RJ-45, if required, select
the
Ethernet port crossover
check box
to inverse the pin-to-pair assignment of
the UTP cable used.
Note:
At this point you should have a link up indicated in the
Tree
view tab. A
green LED indicates a link up while a red LED indicates a link down. For
electrical port, if the link is down, make sure that the
Ethernet port
crossover
setting is correct.
2d.
Press
Next
.
