Summary Tabs
132
IQS-8500 Series and IQS-8120NGE/8130NGE
Test Logger
Logger Table
An event is automatically listed in the logger and saved on the hard drive in
case a power failure condition occurs.
The logger is cleared when one of the following conditions is met:
A test case is stopped and restarted.
The test case is cleared.
When pressing
.
Events are listed by
ID - Date/Time
by default. Events can also be sorted by
Data Path
or
Event
by pressing on the corresponding column title.
ID
: Indicates the Event number. Events are sequentially numbered.
Date/Time
: Indicates the date and time the Alarm/Error condition has
been detected.
Data Path
: Indicates the origin of the alarm/error. [P1] and [P2] in the
data path represent respectively the Port 1 and Port 2. Port 2 is only
available with IQS-8510B.
Event
: Indicates the alarm/error type.
Duration
: Indicates the number of seconds (day:hour:minute:second
format) within which the alarm/error occurred.
Count
: Indicates the number of occurrences of the error.
Rate
: Indicates the error rate.
Note:
In the Duration, Count and Rate columns,
Pending
indicates that the
alarm/error condition persists or was persisting when the test was stopped.
