Port Tabs
Ethernet and Fibre Channel Application
153
Network
For IPv6:
Displays the
Link-Local IPv6 Address
,
Global IPv6 Address
, and
Default Gateway Address
.
IPv6 Config
button allows to configure the IPv6 addresses. Refer to
on page 487 for more information.
Frame Format
Frame Format
allows to select
Ethernet II
or
802.3 SNAP
frame
format.
OUI
is available when the frame format 802.3 SNAP is selected and it
allows the selection of the Organizationally Unique Identifier (OUI).
Choices are
RFC1042
, and
802.1H
. The
OUI
selection is not coupled
when the
Coupled to stream
check box is selected.
MPLS
MPLS settings are only available when MPLS is enabled from the test setup
and allow to transmit and receive management frames (ex: PING) inside a
core MPLS network.
Label TX
and
RX
: Allows the selection of the interface MPLS TX and RX
labels (
0
to
1048575
). The default label value is
16
for both TX and RX. The
TX and RX labels are available when the
MPLS
check box from the test
setup is selected.
PBB-TE
PBB-TE settings are only available when PBB-TE is enabled from the test
setup and allow to configure the interface source and destination
parameters allowing to exist on a PBB-TE network. Refer to
on page 483 for more information.
