RFC 2544 Tabs
318
IQS-8500 Series and IQS-8120NGE/8130NGE
Latency
Configuration
Test Time (MM:SS)
: Select the test time value. Choices are
1
second to
2
minutes (RFC). The default setting is
1
second (00:01).
Nb. of Trials to Average
: Select the number of trials to average.
Choices are from
1
to
50
trials. The default setting is
1
trial.
Minimum Test Time (Seconds)
: Indicates the minimum time the test
requires to run at best condition. The minimum test time is calculated
and updated once the test is started.
Maximum Rate
: The maximum rate can be entered manually by typing
the value for each frame size in the
TX-to-RX/P1-to-P2
/
P2-to-P1
/
Local
to Remote
/
Remote to Local
column or using the
Set All to
, or by
enabling the
Copy From Throughput Test
.
P1-to-P2/P2-to-P1
is only
available with IQS-8510B.
TX-to-RX/P1-to-P2
/
P2-to-P1
/
Local to Remote
/
Remote to Local
:
Enter the value for each frame size. Choices are listed in the
following table. The default setting is
100%
.
P1-to-P2/P2-to-P1
is
only available with IQS-8510B.
Unit
Interface
Rate
from
to
%
10 Mbps
100 Mbps
1000 Mbps
10 Gig-E LAN
10 Gig-E WAN
0.005
0.005
0.005
0.005
0.005
100
100
100
100.0
92.8571428571429
Mbps
10 Mbps
100 Mbps
1000 Mbps
0.0005
0.005
0.05
10
100
1000
Gbps
10Gig-E LAN
10Gig-E WAN
0.0005
0.0005
10.0
9.2857142857142865
