Tools Tabs
Ethernet and Fibre Channel Application
397
Ping Configuration
Delay (ms)
: Available for ping only. Enter the delay between each
attempt (PING). Choices are
100
to
10000 ms
. The default setting is
1000 ms
.
Data Size (Bytes)
: Available for ping only. Enter the buffer size that will
be sent to the network device to be detected. Choices are
0
to
1472
bytes
. Default value is
32 bytes
.
Time To Live (TTL) for IPv4
Hop Limit (TTL) for IPv6
Enter the maximum number of hops the packet can go through.
Choices are
1
to
255
. The default setting is
128
.
Flow Label
(IPv6 only): Enter the
Flow Label
number that will be used
to identify a series of related packets from a source to a destination.
Choices are
0
to
1048575
. The default setting is
0
.
Attempts
and
Continuous
: Enter the number of attempt that will be
performed to reach the network device or press
Continuous
to
attempt indefinitely. Choices are
1
to
100
. The default setting is
4
and
Continuous
is disabled.
Type Of Service (TOS) for IPv4
Traffic Class (TOS) for IPv6
Enter the type of service. Choices are
00
to
FF
. The default setting is
00
.
Binary
: Enable binary to set the TOS field in binary mode. Otherwise,
the TOS field is in hexadecimal mode. This setting is disabled by
default.
