Creating and Starting a Test Case
78
IQS-8500 Series and IQS-8120NGE/8130NGE
EtherSAM (Y.1564) Test Case
4g.
For IPv6, press the
IPv6 Config
button to set the IPv6 settings.
on page 487 for more
information.
4h.
Press
Next
.
5.
Service configuration
5a.
For IPv4, select the
Automatic IP
Address
check box to dynamically
obtain an IP address from a DHCP
(Dynamic Host Configuration Protocol)
server or set the source and destination
IP addresses,
Subnet Mask
, and the
Default Gateway
. Refer to
information.
5b.
For IPv6, set the destination IP address
and if required, press the
IPv6 Config
button for additional IPv6 settings. Refer
to
page 487 for more information.
5c.
If required, set the source and
destination MAC addresses, and select
the
Resolve MAC Address
check box
when required. Refer to page 332 for
more information.
5d.
Select the
Frame Format
. Choices are
Ethernet II
and
802.3 SNAP
. Refer to
page 494 for more information.
5e.
Set the
VLAN
parameters when required. Refer to
on page 482 for more information.
5f.
Press
Finish
to complete the test setup.
