Creating and Starting a Test Case
82
IQS-8500 Series and IQS-8120NGE/8130NGE
Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test Set Test Cases
2.
Port configuration:
Port 1
(IQS-8510B only) is automatically selected.
2a.
Select the port
Connector
Type (Optical
or
Electrical RJ-45
).
Optical
is automatically selected for the
Ethernet 10G
interface.
2b.
For Electrical RJ-45, if required, select
the
Ethernet port crossover
check box
to inverse the pin-to-pair assignment of
the UTP cable used.
Note:
At this point you should have a link up indicated in the
Tree
view tab. A
green LED indicates a link up while a red LED indicates a link down. For
electrical port, if the link is down, make sure that the
Ethernet port
crossover
setting is correct.
2c.
Press
Next
.
